BeltedGirls.com

I am in the process of making my own steel chastity belt but was wondering if there is any place where I can get a shackleguard like what is on most chastity devices. The kind with a flat round face where a small padlock is used.

Hello Amy
Welcome
I would think an internet search should bring up a few options.
Try Security locks
Lock smiths
Hardware suppliers
RADIAL LOCKS/ CABINET LOCKS/ PICK RESISTANT.
I think if you search Belted girls there have been a few hand built /modified belts that have mentioned the locks used.
SEARCH BY Alphabet MEMBER LISTINGS dashing darla [USA] Pyra Gargon built a great belt also USA.
Good luck and if you have time tell us how far you have got so far . So photos would be nice

Fitherin
A location country that you are in might save some time with shipping taxess etc

I finally remembered a firm that make locks similar to the lock barrel in my Tollyboy belt

https://www.camlock.com/en-uk

Worth looking at may be what your looking for

F

High Security Computer Case Lock # 2607
http://www.fjmsecurity.com/Computer-Locks.php



But I think you would like this part on this image?

I have not seen any that are sold without you also buy a Chinese chastity belt.

Tobbe wrote:High Security Computer Case Lock # 2607
http://www.fjmsecurity.com/Computer-Locks.php



(

This looks very similar to the Tollyboy lock and looks excellent to me, BehindBarz use somehing similar too.

I believe it is this type of lock Behind Bars uses.
They are significantly smaller than Tollyboy, but certainly works well.

Those computer locks are merely screws with unusual bits, surrounded by something to keep a casual intruder from using pliers. It would be neat if those were real tubular pin tumbler locks, with unique keys, but alas, they are not.

Perhaps there's a variant type with a real key-- but the sites I'm seeing like to confuse the issue.

Correct. Those are just a fancy screw heads with a radial key-like driver.

These actually have tumblers though none of them are as low profile as a basic screw/driver design:

https://www.alibaba.com/product-detail/ ... 73032.html
https://korean.alibaba.com/product-deta ... 48832.html

Molly

The computer case locks that I bought are really locks, pin and all, have a 6/32" male stud which can be shortened. Unfortunately, they all seem to use the same key, a '0050'.
Not much security in that - kind of like the Motorola '2137' key or the CH751.